Configuring Dhcp - Cisco RV180 Administrator's Manual
Hide thumbs
Also See for RV180:
- Administration manual (187 pages) ,
- Manual (14 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Configuring Networking
Configuring the LAN (Local Network) Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV180/RV180W Administration Guide
To configure the IP address of the Cisco RV180/RV180W:
Choose Networking > LAN (Local Network) > IPv4 LAN (Local Network).
Enter this information:
IP Address
Subnet mask
Click Save.
After changing the Cisco RV180/RV180W's LAN IP address, your PC is no longer
connected to the Cisco RV180/RV180W.
To reconnect your PC to the Cisco RV180/RV180W:
•
If DHCP is configured on the Cisco RV180/RV180W, release and renew your
PC's IP address.
•
If DHCP is not configured on the Cisco RV180/RV180W, manually assign an
IP address to your PC. The address must be on the same subnet as the Cisco
RV180/RV180W. For example, if you change the Cisco RV180/RV180W's
IP address to 10.0.0. 1 , assign your PC an IP address in the range of 10.0.0.2
to 10.0.0.254.
Open a new browser window and enter the new IP address of the Cisco RV180/
RV180W to reconnect.
Configuring DHCP
By default, the Cisco RV180/RV180W functions as a DHCP server to the hosts on
the Wireless LAN (WLAN) or LAN network and assigns IP and DNS server
addresses.
Enter the LAN IP address of the RV180/RV180W.
Make sure the address is not in use by another
device on the same network. The default IP
address is 192. 1 68. 1 . 1 .
Choose the subnet mask for the new IP address
from the drop-down menu. The default subnet is
255.255.255.0.
2
33
Advertisement
Table of Contents
