Adjusting The Tracking; Checking The Tire Pressure - Toro 74933 Operator's Manual
With 60in or 72in turbo force side discharge mower
Hide thumbs
Also See for 74933:
- Operator's manual (68 pages) ,
- Operator's manual (80 pages) ,
- Operator's manual (80 pages)
Table of Contents
Advertisement
2
3
4
1. ROPS knob (locked position)
2. Pull ROPS knob out and rotate 90 degrees to change roll
bar position
3. Roll bar in the upright position
4. Roll bar in the folded position
Adjusting the Tracking
1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the motion-control
levers to the
NEUTRAL
3. Move the throttle midway between
4. Move both motion-control levers all the way forward
until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until the
machine tracks straight
7. If it tracks to the left, loosen the bolts and adjust the
right stop plate rearward on the right T-slot until the
machine tracks straight
8. Tighten the stop plate
1
Figure 60
-
position.
LOCK
and
FAST
(Figure
61).
(Figure
61).
(Figure
61).
1. Control lever
g021420
2. Bolt
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
Maintain the air pressure in the rear tires at 13 psi (90 kPa).
Uneven tire pressure can cause uneven cut. Check the tires
when they are cold to get the most accurate pressure reading.
Note: The front tires are semi-pneumatic tires and do not
require air-pressure maintenance.
.
SLOW
46
Figure 61
Left control lever shown
3. Stop plate
comes first)
Figure 62
g027424
Advertisement
Table of Contents
