Installing The Cable Management Arm (Optional) - Cisco UCS C240 M4 Installation And Service Manual
Hide thumbs
Also See for UCS C240 M4:
- Installation and service manual (150 pages) ,
- Installation and service manual (146 pages) ,
- Upgrade manual (11 pages)
Table of Contents
Advertisement
Installing the Server In a Rack
Installing the Cable Management Arm (Optional)
Note
With the server pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the
Step 1
server onto the end of the stationary slide rail that is attached to the rack post (see
tab over the end of the rail until it clicks and locks.
Slide the CMA tab that is closest to the server over the end of the inner rail that is attached to the server
Step 2
(see
Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the
Step 3
width of your rack (see
Step 4
Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide
rail that is attached to the rack post (see
and locks.
Step 5
Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides
as desired.
Figure 2-4
3
1
2
Cisco UCS C240 M4 Server Installation and Service Guide
2-8
The CMA is reversible left to right. To reverse the CMA, see
Arm (Optional), page 2-9
Figure
2-4). Slide the tab over the end of the rail until it clicks and locks.
Figure
Attaching the Cable Management Arm to the Rear of the Slide Rails
CMA tab on arm farthest from server and end
of stationary outer slide rail
CMA tab on arm closest to the server and end
of inner slide rail attached to server
before installation.
2-4).
Figure
2-4). Slide the tab over the end of the rail until it clicks
2
3
CMA tab on width-adjustment slider and end
of stationary outer slide rail
4
Rear of server
Chapter 2
Installing the Server
Reversing the Cable Management
Figure
2-4). Slide the
1
4
OL-32474-01
Hide quick links:
Advertisement
Table of Contents
