Installing The Switch In A Rack; Attaching The Brackets To The Switch - Cisco WS-C2950-24 Hardware Installation Manual
Hide thumbs
Also See for WS-C2950-24:
- Configuration manual (360 pages) ,
- Installation manual (220 pages) ,
- Datasheet (19 pages)
Table of Contents
Advertisement
Installing the Switch in a Rack
Installing the Switch in a Rack
Warning
Note
Attaching the Brackets to the Switch
Catalyst 2950 Desktop Switch Hardware Installation Guide
2-10
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable.
The following guidelines are provided to ensure your safety:
•
This unit should be mounted at the bottom of the rack if it is the only unit
in the rack.
When mounting this unit in a partially filled rack, load the rack from the
•
bottom to the top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
Figure 2-1
to
Figure 2-14
2950G-48-EI switches as examples. You can install other Catalyst 2950
switches in a rack as shown in these illustrations.
To install the switch in a 19-, 23-, or 24-inch rack, follow these steps:
Attaching the brackets to the switch
•
Mounting the switch in a rack
•
•
Attaching the optional cable guide
The bracket orientation and the screws that you use depend on whether you are
attaching the brackets to a 19-, 23-, or 24-inch rack. Follow these guidelines:
When mounting a switch other than a Catalyst 2950G-48-EI switch in a
•
19-inch rack, use two of the Phillips flat-head screws to attach the long side
of the 19- or 24-inch bracket to the switch. See
Figure
2-3.
show the Catalyst 2950-24, 2950G-24-EI-DC, and
Chapter 2
Installation
Figure
2-1,
Figure
2-2, and
78-11157-02
Hide quick links:
Advertisement
Table of Contents
