Configuring Snmp Traps For Rep - Cisco Catalyst 4500 Series Configuration Manual
Release ios xe 3.3.0sg and ios 15.1(1)sg
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1254 pages)
Table of Contents
Advertisement
Monitoring REP
Command
Step 3
Switch(config-if)# rep preempt segment
segment-id
Step 4
Switch(config-if)# end
Step 5
Switch# show rep topology
Configuring SNMP Traps for REP
To configure the switch to send REP-specific traps to notify the SNMP server of link operational status
changes and port role changes, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# snmp mib rep trap-rate value
Step 3
Switch(config)# end
Step 4
Switch# show running-config
Step 5
Switch# copy running-config startup config
To remove the trap, enter the no snmp mib rep trap-rate global configuration command.
This example configures the switch to send REP traps at a rate of 10 per second:
Switch(config)# snmp mib rep trap-rate 10
Monitoring REP
To monitor REP, enter the following privileged EXEC commands
Table 22-1
Command
Switch# show interface [interface-id] rep
[detail]
Switch# show rep topology [segment
segment_id
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
22-14
REP Monitoring Commands
] [
] [
]
archive
detail
Chapter 22
Purpose
Manually triggers VLAN load balancing on the segment.
You must confirm the command before it is executed.
Returns to privileged EXEC mode.
Displays REP topology information.
Purpose
Enters global configuration mode.
Enables the switch to send REP traps, and set the number of
traps sent per second. The range is from 0 to 1000. The default
is 0 (no limit imposed; a trap is sent at every occurrence).
Returns to privileged EXEC mode.
Verifies the REP trap configuration.
(Optional) Saves your entries in the switch startup
configuration file.
Purpose
Displays REP configuration and status for a
specified interface or for all interfaces.
Displays REP topology information for a segment
or for all segments, including the primary and
secondary edge ports in the segment.
Configuring Resilient Ethernet Protocol
(Table
22-1).
OL-25340-01
- Quick Links:
- Resetting a Switch to Factory Default...
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
