This guide addresses only those items. You should use good judgment to identify potential safety hazards due to attachment of non-Lenovo features or options not covered by this inspection guide. If any unsafe conditions are present, you must determine how serious the apparent hazard could be and whether you can continue without first correcting the problem.
4. Check for cracked or bulging batteries. 5. Remove the cover. 6. Check for any obvious non-Lenovo alterations. Use good judgment as to the safety of any non-Lenovo alterations. 7. Check inside the unit for any obvious unsafe conditions, such as metal filings, contamination, water or other liquids, or signs of fire or smoke damage.
Grounding requirements Electrical grounding of the computer is required for operator safety and correct system function. Proper grounding of the electrical outlet can be verified by a certified electrician. Safety notices (multilingual translations) The safety notices in this section are provided in the following languages: •...
• Damage caused by the improper insertion of a personal-computer card (PC card) or the installation of an incompatible card • Improper disc insertion or use of an external optical drive • Fuses blown by attachment of a non-supported device •...
The exploded illustrations help Lenovo service technicians identify FRUs or CRUs that they may need to replace when servicing a customer’s computer. Refer to Appendix B “Lenovo part numbers for replacement FRUs” on page 43 if you need to look up Lenovo part numbers for a particular FRU or CRU.
5. To install a new FRU in place, perform the removal procedure in reverse and follow any notes that pertain to replacement. 6. When replacing a FRU, carefully retain and reuse all screws. If screws are missing, look up the Lenovo parts numbers in Appendix C “Lenovo part numbers for CRUs and miscellaneous parts” on page 45 for replacement screws and order them through the Lenovo CRM system.
Page 32
Figure 3. Pry rubbers out of recesses Note: The recesses and rubbers are marked with capital letters A, B, C, and D. Make sure that all rubbers are put in the right recesses when installing new rubbers. Step 2. Remove the screws. Figure 4.
Open the keyboard and touch pad sockets, detach the cables, and pull up the upper case. Refer to Table 12 “Part numbers for FRUs (CRUs)” on page 43 to look up the Lenovo part numbers for the following replacement parts:...
1.85 +/- pack to 0.15kgf-cm base cover Refer to Table 12 “Part numbers for FRUs (CRUs)” on page 43 to look up the Lenovo part numbers of the following replacement parts: Battery pack Remove the speakers Make sure the following FRUs (CRUs) have been removed.
Remove the two screws and then remove the I/O board. Figure 9. Remove the USB board Refer to Table 12 “Part numbers for FRUs (CRUs)” on page 43 to look up the Lenovo part numbers of replacement USB board. Remove the WLAN & Bluetooth combo module Make sure the following FRUs (CRUs) have been removed and the battery connector has been detached.
Page 36
Pull out the WLAN & Bluetooth combo module in the direction shown by the arrow Figure 12. Pull out the WLAN & Bluetooth combo module Refer to Table 12 “Part numbers for FRUs (CRUs)” on page 43 to look up the Lenovo part numbers of replacement WLAN & Bluetooth combo modules.
Remove the LCD module Make sure the following FRUs (CRUs) have been removed and the battery connector has been detached. “Remove the upper case (with keyboard)” on page 25 “Remove the WLAN & Bluetooth combo module” on page 29 Step 1. Open the socket and detach the LCD cable Figure 13.
Step 3. Lift up the LCD module to detach it from the base cover. The LCD module is not a FRU. Instead, it contains FRUs as its components. Refer to “Disassemble the LCD module” on page 33 if you need to replace a FRU contained in the LCD module. Remove the system board and the DC-in cable “Remove the upper case (with keyboard)”...
Step 3. Remove the DC-in cable. Figure 17. Remove the DC-in cable Refer to Table 12 “Part numbers for FRUs (CRUs)” on page 43 to look up the Lenovo part numbers of the following replacement parts: System board DC-in cable...
Page 40
Figure 18. Pry the six rubbers Step 2. Remove the six screws Figure 19. Remove 6 screws Table 8. Screw specifications — removing the LCD bezel Screw location Number Specifications Color Torque Black LCD bezel to M2.5 × 3.5 mm, flat-head, nylon-coated 3.7 —...
Step 4. Remove the LCD bezel. Refer to Table 13 “Part numbers for LCD FRUs” on page 44 to look up the Lenovo part numbers for the replacement LCD bezel. Remove the LCD panel Make sure the following FRUs (or CRUs) have been removed.
Figure 22. Disconnect the LCD cable from the back of the LCD panel Step 3. Remove the LCD panel. Refer to Table 13 “Part numbers for LCD FRUs” on page 44 to look up the Lenovo part numbers for replacement LCD panels. Remove the camera assembly or the LCD & camera cable Make sure the following FRUs (or CRUs) have been removed.
Page 43
If you need to replace the camera assembly, remove the two screws that secure the camera on the LCD base cover. Figure 26. Remove the camera module Refer to Table 13 “Part numbers for LCD FRUs” on page 44 to look up the Lenovo part numbers for replacement parts for: Camera assembly LCD &...
Assemble camera parts The replacement camera assembly came in several parts. You need to connect the LCD cable to the connector on the camera board and assemble the various parts before install it on the LCD module. Step 1. Connect the LCD cable with the camera board. Figure 27.
Page 45
LCD base cover Step 2. Remove the hinges. Refer to Appendix B “Lenovo part numbers for replacement FRUs” on page 43 to look up the Lenovo part numbers for the replacement hinges. Chapter 4 Removing a FRU or CRU...
Appendix B. Lenovo part numbers for replacement FRUs When servicing a customer’s computer, Lenovo service technicians may use part numbers listed in the following tables to order replacement parts through Lenovo CRM (customer relationship management) system. Table 12. Part numbers for FRUs (CRUs) No.
Page 50
Lower Case Q 80SF 5CB0L13240 Note: Refer to Appendix C “Lenovo part numbers for CRUs and miscellaneous parts” on page 45 to look up the Lenovo part numbers of ac power adapters and power cords. Table 13. Part numbers for LCD FRUs No.
Appendix C. Lenovo part numbers for CRUs and miscellaneous parts The power cords and ac adapters are CRUs. Table 14. Part numbers for FRUs (CRUs) CRU category Parts description Lenovo part number Screw pack Screw Pack Q 80SF 5C20H70344 Rubber pack...
Trademarks Lenovo and the “lenovo” logo are trademarks of Lenovo in the United States, other countries or both: Other company, product, or service names may be trademarks or service marks of others.