Configuring The Wireless Device; Starting A Wireless Configuration Session - Cisco 1941W Configuration Manual
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
Configuring the Wireless Device
The following sections describe how to configure the wireless device on the Cisco 1941W integrated
services router (ISR):
•
•
•
•
Note
You can upgrade the software on the device to Cisco Unified software. See the
Unified Software" section on page
Note
The wireless device is embedded on the router and does not have an external console port for
connections. To configure the wireless device, use a console cable to connect a personal computer to the
host router's Console serial port, and follow the instruction to establish a configuration session.
Starting a Wireless Configuration Session
Enter the following commands in global configuration mode on the router's Cisco IOS command-line
interface (CLI).
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Starting a Wireless Configuration Session, page 247
Configuring Wireless Settings, page 249
Upgrading to Cisco Unified Software, page 255
Related Documentation, page 258
interface wlan-ap0
ip address subnet mask
no shut
interface vlan1
ip address subnet mask
exit
exit
service-module wlan-ap 0 session
255.
"Upgrading to Cisco
247
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
