Cisco 1941W Configuration Manual page 304
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
Disabling the Mode Button Function
This command disables password recovery. If you lose the privileged EXEC mode password for the
Caution
access point after entering this command, you will need to contact the Cisco Technical Assistance Center
(TAC) to regain access to the access point command line interface (CLI).
To reboot the wireless device, use the service-module wlan-ap reset command from the Cisco IOS CLI.
Note
See the
The mode button is enabled by default. To disable the access point's mode button, Follow these steps,
beginning in privileged EXEC mode.
SUMMARY STEPS
1.
2.
3.
DETAILED STEPS
Command
Step 1
configure terminal
Step 2
no boot mode-button
Step 3
end
You can check the status of the mode button by executing the show boot or show boot mode-button
command in privileged EXEC mode. The status does not appear in the running configuration. The
following shows typical responses to the show boot and show boot mode-button commands:
ap# show boot
BOOT path-list: flash:/c1200-k9w7-mx-v123_7_ja.20050430/c1200-k9w7-mx.v123_7_ja.20050430
Config file: flash:/config.txt
Private Config file: flash:/private-config
Enable Break: no
Manual boot:no
Mode button:on
Enable IOS break: no
HELPER path-list:
NVRAM/Config file
ap#show boot mode-button
on
ap#
As long as the privileged EXEC password is known, you can use the boot mode-button command to
Note
restore the mode button to normal operation.
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
296
"Rebooting the Wireless Device" section on page 314
configure terminal
no boot mode-button
end
Purpose
Enters global configuration mode.
Disables the access point's mode button.
Returns to privileged EXEC mode.
Note
buffer size: 32768
for information about this command.
It is not necessary to save the configuration.
Chapter
Administering the Wireless Device
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
