Load Or Unload Tool In Magazine - Siemens SINUMERIK 840D Operator's Manual
Computerized
numerical control system for machine tools
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
5
Parameters Operating Area
5.5 Tool management ShopTurn
5.8
Load or unload tool in magazine
Machine manufacturer
Load a tool into the
magazine
Load
5-172
The tool data of the selected tool are deleted, the magazine location
in which the deleted tool was located is enabled.
The tool is not deleted with "Abort".
The tool list has more locations than magazine locations. This means
you can unload tools you currently do not need in the magazine and
save the tool data in the tool list outside the magazine. If you want to
use the tool again at a later point in time, simply load the tool data
back to the magazine location. Then the same tool data does not
have to be entered more than once.
Loading and unloading of tool data into and out of magazine locations
must be enabled in a machine data code.
Please follow the machine manufacturer's instructions!
Operating sequence
Place the cursor on the tool that you want to load into the magazine (if
the tools are sorted according to magazine location number you will
find it at the end of the tool list).
Press the "Load" softkey.
The "Empty location" window appears. The "Location" field is
initialized with the number of the first empty magazine location.
Press the "OK" softkey to load the tool into the suggested location.
-or-
Enter the desired location number and press the "OK" softkey.
The data relating to your tool are now displayed in the specified
magazine location.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
Siemens AG, 2004. All rights reserved
Advertisement
Table of Contents
