Display Options: Masking Filter - Siemens SINUMERIK 840D Operator's Manual
Computerized
numerical control system for machine tools
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
9
Start-Up Operating Area
9.2 Display machine data
MSD
Find...
Keep
searching
9.2.1 Display options: Masking filter
9-300
Machine data for the main spindle drive,
Vertical softkeys
To find a specific machine datum, press the "Find..." softkey. Enter
the name or number of the machine data you are looking for and
press the "OK" softkey.
After pressing the "Keep searching" softkey, you move from one
datum to the next in the machine data list.
Function
The purpose of masking filters is to selectively reduce the number of
displayed machine data. For this function, all machine data in areas
•
General machine data
•
Channel-specific machine data
•
Axis-specific machine data
•
Drive configurations
are assigned to specific groups (e.g. configuration data, etc.).
The following applies:
1.
Each area has its own group organization.
2.
Each group corresponds to one bit in the filter word ("spare" bit in
previous SW)
3.
Each area has a maximum of 13 groups (group 14 is reserved for
Expert mode (see below), bit 15 is reserved for expansions).
Display machine data do not have any group organization.
Filter criteria
The following table shows the criteria for displaying machine data in
the order in which they are evaluated:
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
9
03.04
Siemens AG, 2004. All rights reserved
Advertisement
Table of Contents
