Classless Routing - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Configuring IP Addressing
Command
Step 6
end
Step 7
show ip route
show ip interface [interface-id]
show running-config interface [interface-id]
Step 8
copy running-config startup-config
On switches running the LAN base image, you can only assign an IP address to an SVI and then
configure a static route for the SVI.The switch supports 16 user-configured static routes. See the
"Configuring Static Unicast Routes" section on page
supported.
Use of Subnet Zero
Subnetting with a subnet address of zero is strongly discouraged because of the problems that can arise
if a network and a subnet have the same addresses. For example, if network 131.108.0.0 is subnetted as
255.255.255.0, subnet zero would be written as 131.108.0.0, which is the same as the network address.
You can use the all ones subnet (131.108.255.0) and even though it is discouraged, you can enable the
use of subnet zero if you need the entire subnet space for your IP address.
Beginning in privileged EXEC mode, follow these steps to enable subnet zero:
Command
Step 1
configure terminal
Step 2
ip subnet-zero
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup-config
Use the no ip subnet-zero global configuration command to restore the default and disable the use of
subnet zero.
Classless Routing
By default, classless routing behavior is enabled on the switch when it is configured to route. With
classless routing, if a router receives packets for a subnet of a network with no default route, the router
forwards the packet to the best supernet route. A supernet consists of contiguous blocks of Class C
address spaces used to simulate a single, larger address space and is designed to relieve the pressure on
the rapidly depleting Class B address space.
In
Figure
discarding the packet, the router forwards it to the best supernet route. If you disable classless routing
and a router receives packets destined for a subnet of a network with no network default route, the router
discards the packet.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-8
Purpose
Enter global configuration mode.
Enable the use of subnet zero for interface addresses and routing updates.
Return to privileged EXEC mode.
Verify your entry.
(Optional) Save your entry in the configuration file.
1-2, classless routing is enabled. When the host sends a packet to 120.20.4.1, instead of
Purpose
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
1-94. No other routing configurations are
Chapter 1
Configuring IP Unicast Routing
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
