Cisco Catalyst 3560-X Software Configuration Manual page 1120
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Configuring ISO CLNS Routing
•
•
•
•
Beginning in privileged EXEC mode, follow these steps to configure IS-IS interface parameters:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
isis metric default-metric [level-1 |
level-2]
Step 4
isis hello-interval {seconds |
minimal} [level-1 | level-2]
Step 5
isis hello-multiplier multiplier
[level-1 | level-2]
Step 6
isis csnp-interval seconds [level-1 |
level-2]
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-74
frequently and IS-IS adjacencies are failing unnecessarily. You can raise the hello multiplier and
lower the hello interval correspondingly to make the hello protocol more reliable without increasing
the time required to detect a link failure.
Other time intervals:
–
Complete sequence number PDU (CSNP) interval. CSNPs are sent by the designated router to
maintain database synchronization
Retransmission interval. This is the time between retransmission of IS-IS LSPs for
–
point-to-point links.
IS-IS LSP retransmission throttle interval. This is the maximum rate (number of milliseconds
–
between packets) at which IS-IS LSPs are re-sent on point-to-point links This interval is
different from the retransmission interval, which is the time between successive retransmissions
of the same LSP
Designated router election priority, which allows you to reduce the number of adjacencies required
on a multiaccess network, which in turn reduces the amount of routing protocol traffic and the size
of the topology database.
The interface circuit type, which is the type of adjacency desired for neighbors on the specified
interface
Password authentication for the interface
Purpose
Enter global configuration mode.
Specify the interface to be configured and enter interface configuration
mode. If the interface is not already configured as a Layer 3 interface, enter
the no switchport command to put it into Layer 3 mode.
(Optional) Configure the metric (or cost) for the specified interface. The
range is from 0 to 63. The default is 10. If no level is entered, the default is
to apply to both Level 1 and Level 2 routers.
(Optional) Specify the length of time between hello packets sent by the
switch. By default, a value three times the hello interval seconds is
advertised as the holdtime in the hello packets sent. With smaller hello
intervals, topological changes are detected faster, but there is more routing
traffic.
•
•
(Optional) Specify the number of IS-IS hello packets a neighbor must miss
before the router should declare the adjacency as down. The range is from
3 to 1000. The default is 3. Using a smaller hello-multiplier causes fast
convergence, but can result in more routing instability.
(Optional) Configure the IS-IS complete sequence number PDU (CSNP)
interval for the interface. The range is from 0 to 65535. The default is
10 seconds.
minimal—causes the system to compute the hello interval based on the
hello multiplier so that the resulting hold time is 1 second.
seconds—the range is from 1 to 65535. The default is 10 seconds.
Chapter 1
Configuring IP Unicast Routing
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
