X Authentication With Downloadable Acls And Redirect Urls - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Understanding IEEE 802.1x Port-Based Authentication
You can use the Filter-Id attribute to specify an inbound or outbound ACL that is already configured on
the switch. The attribute contains the ACL number followed by .in for ingress filtering or .out for egress
filtering. If the RADIUS server does not allow the .in or .out syntax, the access list is applied to the
outbound ACL by default. Because of limited support of Cisco IOS access lists on the switch, the
Filter-Id attribute is supported only for IP ACLs numbered 1 to 199 and 1300 to 2699 (IP standard and
IP extended ACLs).
Only one 802.1x-authenticated user is supported on a port. If the multiple-hosts mode is enabled on the
port, the per-user ACL attribute is disabled for the associated port.
The maximum size of the per-user ACL is 4000 ASCII characters but is limited by the maximum size of
RADIUS-server per-user ACLs.
For examples of vendor-specific attributes, see the
RADIUS Attributes" section on page
Chapter 1, "Configuring Network Security with ACLs."
To configure per-user ACLs:
•
•
•
•
•
Note
802.1x Authentication with Downloadable ACLs and Redirect URLs
You can download ACLs and redirect URLs from a RADIUS server to the switch during 802.1x
authentication or MAC authentication bypass of the host. You can also download ACLs during web
authentication.
A downloadable ACL is also referred to as a dACL.
Note
If more than one host is authenticated and the host is in single-host, MDA, or multiple-authentication
mode, the switch changes the source address of the ACL to the host IP address.
You can apply the ACLs and redirect URLs to all the devices connected to the 802.1x-enabled port.
If no ACLs are downloaded during 802.1x authentication, the switch applies the static default ACL on
the port to the host. On a voice VLAN port configured in multi-auth or MDA mode, the switch applies
the ACL only to the phone as part of the authorization policies.
Beginning with Cisco IOS Release 12.2(55)SE, if there is no static ACL on a port, a dynamic
auth-default ACL is created, and policies are enforced before dACLs are downloaded and applied.
The auth-default-ACL does not appear in the running configuration.
Note
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-18
Enable AAA authentication.
Enable AAA authorization by using the network keyword to allow interface configuration from the
RADIUS server.
Enable 802.1x authentication.
Configure the user profile and VSAs on the RADIUS server.
Configure the 802.1x port for single-host mode.
Per-user ACLs are supported only in single-host mode.
Chapter 1
Configuring IEEE 802.1x Port-Based Authentication
"Configuring the Switch to Use Vendor-Specific
1-35. For more information about configuring ACLs, see
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
