Monitoring Interface Status - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Monitoring and Maintaining the Interfaces
Monitoring Interface Status
Commands entered at the privileged EXEC prompt display information about the interface, including
the versions of the software and the hardware, the configuration, and statistics about the interfaces.
Table 1-6
commands by using the show ? command at the privileged EXEC prompt.) These commands are fully
described in the Cisco IOS Interface Command Reference, Release 12.4.
Table 1-6
Show Commands for Interfaces
Command
show env power switch [switch-number]
show env rps
show env rps detail
show env rps switch [switch-number]
show interfaces [interface-id]
show interfaces interface-id status [err-disabled]
show interfaces [interface-id] switchport
show interfaces [interface-id] description
show ip interface [interface-id]
show interface [interface-id] stats
show interfaces interface-id
show interfaces transceiver dom-supported-list
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-52
lists some of these interface monitoring commands. (You can display the full list of show
Purpose
(Optional) Displays the status of the internal power supplies for each
switch in the stack or for the specified switch. The range is 1 to 9,
depending on the switch member numbers in the stack.
These keywords are available only on Catalyst 3750-E switches.
Displays whether a redundant power system (RPS) is connected to the
switch as follows:
(Optional) Displays the details about the RPSs that are connected to
the switch or switch stack.
(Optional) Displays the RPSs that are connected to each switch in the
stack or to the specified switch. The range is 1 to 9, depending on the
switch member numbers in the stack.
Displays the status and configuration of all interfaces or a specific
interface.
Displays interface status or a list of interfaces in the error-disabled
state.
Displays administrative and operational status of switching
(nonrouting) ports. You can use this command to find out if a port is in
routing or in switching mode.
Displays the description configured on an interface or all interfaces
and the interface status.
Displays the usability status of all interfaces configured for IP routing
or the specified interface.
Displays the input and output packets by the switching path for the
interface.
(Optional) Displays speed and duplex on the interface.
(Optional) Displays Digital Optical Monitoring (DOM) status on the
connect SFP modules.
Chapter 1
–
Catalyst 3750-E or 3560-E switch—Cisco Redundant Power
System 2300, also referred to as the RPS 2300.
–
Catalyst 3750v2 or 3560v2 switch—Cisco Redundant Power
System 2300.
Catalyst 3750, 3560, 2970, or 2960 switches—RPS 2300 or
–
Cisco RPS 675 Redundant Power System, also referred to as
the RPS 675.
Configuring Interface Characteristics
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
