Default Mld Snooping Configuration; Mld Snooping Configuration Guidelines - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Configuring IPv6 MLD Snooping
Default MLD Snooping Configuration
Table 1-1
Feature
MLD snooping (Global)
MLD snooping (per VLAN)
IPv6 Multicast addresses
IPv6 Multicast router ports
MLD snooping Immediate Leave
MLD snooping robustness variable
Last listener query count
Last listener query interval
TCN query solicit
TCN query count
MLD listener suppression
MLD Snooping Configuration Guidelines
When configuring MLD snooping, consider these guidelines:
•
•
•
•
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-6
Default MLD Snooping Configuration
You can configure MLD snooping characteristics at any time, but you must globally enable MLD
snooping by using the ipv6 mld snooping global configuration command for the configuration to
take effect.
When the IPv6 multicast router is a Catalyst 6500 switch and you are using extended VLANs (in the
range 1006 to 4094), IPv6 MLD snooping must be enabled on the extended VLAN on the
Catalyst 6500 switch in order for the Catalyst 3750-X or 3560-X switch to receive queries on the
VLAN. For normal-range VLANs (1 to 1005), it is not necessary to enable IPv6 MLD snooping on
the VLAN on the Catalyst 6500 switch.
MLD snooping and IGMP snooping act independently of each other. You can enable both features
at the same time on the switch.
The maximum number of multicast entries allowed on the switch or switch stack is determined by
the configured SDM template.
The maximum number of address entries allowed for the switch or switch stack is 1000.
Default Setting
Disabled.
Enabled. MLD snooping must be globally enabled for VLAN
MLD snooping to take place.
None configured.
None configured.
Disabled.
Global: 2; Per VLAN: 0.
Note
The VLAN value overrides the global setting. When the
VLAN value is 0, the VLAN uses the global count.
Global: 2; Per VLAN: 0.
Note
The VLAN value overrides the global setting. When the
VLAN value is 0, the VLAN uses the global count.
Global: 1000 (1 second); VLAN: 0.
The VLAN value overrides the global setting. When the
Note
VLAN value is 0, the VLAN uses the global interval.
Disabled.
2.
Disabled.
Chapter 1
Configuring IPv6 MLD Snooping
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
