Enabling Or Disabling Mld Snooping - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 1
Configuring IPv6 MLD Snooping
Enabling or Disabling MLD Snooping
By default, IPv6 MLD snooping is globally disabled on the switch and enabled on all VLANs. When
MLD snooping is globally disabled, it is also disabled on all VLANs. When you globally enable MLD
snooping, the VLAN configuration overrides the global configuration. That is, MLD snooping is enabled
only on VLAN interfaces in the default state (enabled).
You can enable and disable MLD snooping on a per-VLAN basis or for a range of VLANs, but if you
globally disable MLD snooping, it is disabled in all VLANs. If global snooping is enabled, you can
enable or disable VLAN snooping.
Beginning in privileged EXEC mode, follow these steps to globally enable MLD snooping on the switch:
Command
Step 1
configure terminal
Step 2
ipv6 mld snooping
Step 3
end
Step 4
copy running-config startup-config
To globally disable MLD snooping on the switch, use the no ipv6 mld snooping global configuration
command.
Beginning in privileged EXEC mode, follow these steps to enable MLD snooping on a VLAN.
Note
When the IPv6 multicast router is a Catalyst 6500 switch and you are using extended VLANs (in the
range 1006 to 4094), IPv6 MLD snooping must be enabled on the extended VLAN on the Catalyst 6500
switch in order for the Catalyst 3750-X or 3560-X switch to receive queries on the VLAN. For
normal-range VLANs (1 to 1005), it is not necessary to enable IPv6 MLD snooping on the VLAN on the
Catalyst 6500 switch.
Command
Step 1
configure terminal
Step 2
ipv6 mld snooping
Step 3
ipv6 mld snooping vlan vlan-id
Step 4
end
Step 5
copy running-config startup-config
To disable MLD snooping on a VLAN interface, use the no ipv6 mld snooping vlan vlan-id global
configuration command for the specified VLAN number.
OL-25303-03
Purpose
Enter global configuration mode.
Globally enable MLD snooping on the switch.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Globally enable MLD snooping on the switch.
Enable MLD snooping on the VLAN.The VLAN ID range is 1 to
1001 and 1006 to 4094.
MLD snooping must be globally enabled for VLAN snooping
Note
to be enabled.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring IPv6 MLD Snooping
1-7
Advertisement
Table of Contents
Troubleshooting
