Editing Commands Through Keystrokes - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 1
Using the Command-Line Interface
To re-enable the enhanced editing mode for the current terminal session, enter this command in
privileged EXEC mode:
Switch# terminal editing
To reconfigure a specific line to have enhanced editing mode, enter this command in line configuration
mode:
Switch(config-line)# editing
Editing Commands through Keystrokes
Table 1-5
Table 1-5
Editing Commands through Keystrokes
Capability
Move around the command line to
make changes or corrections.
Recall commands from the buffer and
paste them in the command line. The
switch provides a buffer with the last
ten items that you deleted.
Delete entries if you make a mistake
or change your mind.
Capitalize or lowercase words or
capitalize a set of letters.
OL-25303-03
shows the keystrokes that you need to edit command lines. These keystrokes are optional.
1
Keystroke
Press Ctrl-B, or press the
left arrow key.
Press Ctrl-F, or press the
right arrow key.
Press Ctrl-A.
Press Ctrl-E.
Press Esc B.
Press Esc F.
Press Ctrl-T.
Press Ctrl-Y.
Press Esc Y.
Press the Delete or
Backspace key.
Press Ctrl-D.
Press Ctrl-K.
Press Ctrl-U or Ctrl-X.
Press Ctrl-W.
Press Esc D.
Press Esc C.
Purpose
Move the cursor back one character.
Move the cursor forward one character.
Move the cursor to the beginning of the command line.
Move the cursor to the end of the command line.
Move the cursor back one word.
Move the cursor forward one word.
Transpose the character to the left of the cursor with the
character located at the cursor.
Recall the most recent entry in the buffer.
Recall the next buffer entry.
The buffer contains only the last 10 items that you have
deleted or cut. If you press Esc Y more than ten times, you
cycle to the first buffer entry.
Erase the character to the left of the cursor.
Delete the character at the cursor.
Delete all characters from the cursor to the end of the
command line.
Delete all characters from the cursor to the beginning of
the command line.
Delete the word to the left of the cursor.
Delete from the cursor to the end of the word.
Capitalize at the cursor.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Using Editing Features
1-7
Advertisement
Table of Contents
Troubleshooting
