Policing And Marking - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 1
Configuring QoS
The policy map can contain the police and police aggregate policy-map class configuration commands,
which define the policer, the bandwidth limitations of the traffic, and the action to take if the limits are
exceeded.
To enable the policy map, you attach it to a port by using the service-policy interface configuration
command.
You can apply a nonhierarchical policy map to a physical port or an SVI. However, a hierarchical policy
map can only be applied to an SVI. A hierarchical policy map contains two levels. The first level, the
VLAN level, specifies the actions to be taken against a traffic flow on the SVI. The second level, the
interface level, specifies the actions to be taken against the traffic on the physical ports that belong to the
SVI. The interface-level actions are specified in the interface-level policy map.
For more information, see the
information, see the
Policing and Marking
After a packet is classified and has a DSCP-based or CoS-based QoS label assigned to it, the policing
and marking process can begin as shown in
Policing involves creating a policer that specifies the bandwidth limits for the traffic. Packets that exceed
the limits are out of profile or nonconforming. Each policer decides on a packet-by-packet basis whether
the packet is in or out of profile and specifies the actions on the packet. These actions, carried out by the
marker, include passing through the packet without modification, dropping the packet, or modifying
(marking down) the assigned DSCP of the packet and allowing the packet to pass through. The
configurable policed-DSCP map provides the packet with a new DSCP-based QoS label. For information
on the policed-DSCP map, see the
the same queues as the original QoS label to prevent packets in a flow from getting out of order.
All traffic, regardless of whether it is bridged or routed, is subjected to a policer, if one is configured.
Note
As a result, bridged packets might be dropped or might have their DSCP or CoS fields modified when
they are policed and marked.
You can configure policing (either individual or aggregate policers) on a physical port or an SVI. For
more information about configuring policing on physical ports, see the
section on page
and can define an individual policer only in the secondary interface-level policy map. For more
information, see the
After you configure the policy map and policing actions, attach the policy to an ingress port or SVI by
using the service-policy interface configuration command. For configuration information, see the
"Classifying, Policing, and Marking Traffic on Physical Ports by Using Policy Maps" section on
page
section on page
section on page
OL-25303-03
"Policing and Marking" section on page
"Configuring a QoS Policy" section on page
1-10. When configuring policy maps on an SVI, you can create a hierarchical policy map
"Policing on SVIs" section on page
1-58, the
"Classifying, Policing, and Marking Traffic on SVIs by Using Hierarchical Policy Maps"
1-63, and the
"Classifying, Policing, and Marking Traffic by Using Aggregate Policers"
1-71.
Figure
1-4.
"Mapping Tables" section on page
1-11.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Understanding QoS
1-9. For configuration
1-49.
1-13. Marked-down packets use
"Policing on Physical Ports"
1-9
Advertisement
Table of Contents
Troubleshooting
