Table of Contents
Advertisement
Chapter 7 – Maintenance
3
Equipment Upgrade - Key Change
RT430/434
Figure 40: Section to update firmware
To update the unit firmware, access the Setup section of the Web Interface by typing
the unit IP address in a default browser and follow the steps below:
1.
Click <S
> and it will allow the search of a new firmware update file in the
EARCH
directories. Enter the directory and the firmware update file name in the <F
field and it will be sent to the unit. The update file has the extension ".fw430" for
RT430 and ".fw434" for RT434.
2.
Click < S
> to send the new firmware to the unit.
END
3.
After clicking <S
END
configuration password. Enter username and password and click <L
cancel the action, click on <C
4.
During the transmission, the unit will momentarily go out of operation.
5.
After the change is completed, check the main page of the Web Interface.
Note: After updating, it is recommended to clear the browsing data (CTRL+ F5) when
accessing the web interface for the first time.
It is possible to update the unit key in order to enable new features, according to the
commercial policy. Contact sales to acquire a new key to enable the desired features.
Figure 41: Section to equipment upgrade – key change
To change the unit key, access the Setup section from Web Interface, typing the unit
IP address in a default browser and follow the steps below:
1.
Enter the new key (36 alphanumeric characters) in the Key field.
2.
Click <Apply> to send the new key to the unit.
3.
After clicking <Apply>, a new window will open requesting username and
configuration password. Enter username and password and click <Login>. To
cancel the action, click <Cancel>.
4.
During the transmission, the unit will momentarily go out of operation. A
message communicating the key change will show up on the screen.
5.
After the change is completed, check the main page of the Web Interface.
>, a new window will open requesting username and
>.
ANCEL
RT430/434
>
ILE
>. To
OGIN
65
Advertisement
Table of Contents
