Mitsubishi Electric FX3G SERIES Programming Manual page 217
Programmable controllers
Hide thumbs
Also See for FX3G SERIES:
- User manual (532 pages) ,
- Hardware manual (8 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
FX
/FX
/FX
Series Programmable Controllers
3G
3U
3UC
Programming Manual - Basic & Applied Instruction Edition
Cautions on using RST instruction for a jumped program, subroutine program or interrupt program
When RST instruction for a timer or counter is executed in a jumped program, subroutine program or interrupt
program, the timer or counter may be kept in the reset status and the timer or counter may be disabled.
For details, refer to the following sections:
*1
3. Indexing
Devices used in SET and RST instructions can be indexed with index registers (V)(Z).
(State relays (S), special auxiliary relays (M), 32-bit counters, "D .b", and word devices cannot be indexed.)
Circuit program
X000
X001
*1.
This function is supported only in FX
4. Bit specification of a data register (D)
A bit in data register (D) can be specified as a device used in SET or RST instruction.
Circuit program
X000
X001
*1.
This function is supported only in FX
Caution
When SET and RST instructions are executed for an output relay (Y) in the same operation, the result of the
instruction located nearest the END instruction (which specifies the end of program) is output.
Errors
• When an I/O number used in SET or RST instruction does not exist due to indexing, M8316 (Non-existing I/O
specification error) turns ON.
• When the device number of a device (M, T or C) other than I/O used in SET or RST instruction does not exist due
to indexing, an operation error (error code: 6706) occurs.
List program
0000
LD
SET
Y000Z0
0001
SET
0004
LD
0005
RST
RST
Y000Z0
/FX
3U
*1
List program
0000
LD
0001
SET
SET
D0.3
0004
LD
0005
RST
RST
D0.3
/FX
3U
→ For a jumped program, refer to Subsection 8.1.1.
→ For a subroutine program, refer to Subsection 8.2.1.
→ For an interrupt program, refer to Subsection 36.2.3.
V0 to V7 and Z0 to Z7 are available for indexing.
When a used device is an input (X) or output (Y),
the value of an index register (V or Z) is converted
X000
into octal, and then added.
Y000Z0
X001
Example: When Z0 is "20", Y024 turns ON or
Y000Z0
OFF.
PLCs.
3UC
When specifying a bit in data register, input "."
after a data register (D) number, and then input a
bit number (0 to F) consecutively.
X000
Only 16-bit data registers are available.
D0.3
X001
Specify a bit number as "0, 1, 2, ... 9, A, B, ... F"
D0.3
from the least significant bit.
Example: In the example shown on the left, when
X000 turns ON once, the bit 3 of D0
turns ON. When X001 turns ON, the bit
3 of D0 turns OFF.
PLCs.
3UC
7 Basic Instruction
7.13 SET, RST
1
2
3
4
5
6
7
8
9
10
215
Advertisement
Table of Contents
