Mitsubishi Electric FX3G SERIES Programming Manual page 467

Programmable controllers

Hide thumbs Also See for FX3G SERIES:

Table of Contents

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

2. 16-bit conversion mode (while M8161 is OFF)

(M8161 is used also for the RS, ASCI, CCD, and CRC instructions.)

Each ASCII code stored in high-order 8 bits and low-order 8 bits of devices

hexadecimal code, and transferred to devices

converted is specified by "n".

M8161 is used also for the RS, ASCI, CCD and CRC instructions. When using the 16-bit mode, set M8161 to normally

M8161 is cleared when the PLC mode is changed from RUN to STOP.

In the following program, conversion is executed as follows:

Conversion source data

Low-order 8 bits of D200

High-order 8 bits of D200

Low-order 8 bits of D201

High-order 8 bits of D201

Low-order 8 bits of D202

High-order 8 bits of D202

Low-order 8 bits of D203

High-order 8 bits of D203

Low-order 8 bits of D204

Number of specified characters and conversion result

" • " indicates "0".

Does not change

• When the input data is in BCD format, it is necessary to convert BCD data into binary data after executing this

instruction.

• If ASCII code is not stored in

hexadecimal code is disabled. Especially, note that ASCII code should be stored in high-order 8 bits of

when M8161 is OFF.

Hexadecimal code

In the case of "n = K4"

in the HEX instruction, an operation error occurs and conversion into

16 External FX Device – FNC 80 to FNC 89

16.4 FNC 83 – HEX / ASCII to Hexadecimal Conversion

and later in units of 4 digits. The number of characters to be

and later is converted into a

Fx3u series Fx3uc series