Mitsubishi Electric FX3G SERIES Programming Manual page 704

Programmable controllers

Hide thumbs Also See for FX3G SERIES:

Table of Contents

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

• A watchdog timer error may occur when many numbers of points are transferred in one operation cycle. In such a

case, take one of the following countermeasures:

- Change the watchdog timer time

By overwriting the contents of D8000 (watchdog timer time), the watchdog timer detection time is changed (initial

value: K200).

When the program shown below is input, the sequence program will be monitored with the new watchdog timer

Initial pulse

- Change the number of transferred points "n2" in each operation cycle

Change the number of transferred points "n2" in each operation cycle to a smaller value.

• Do not stop the driving of the instruction while it is being executed. If driving is stopped, the buffer memory (BFM)

reading/writing processing is suspended, but the data acquired in the middle of reading/writing processing is stored

and later and buffer memories (BFM).

Instruction execution complete

• When indexing is executed, the contents of index registers at the begining of execution are used.

Even if the contents of index registers are changed after the instruction, such changes do not affect the process of

the instruction.

• The contents of "n1" devices starting from

execution of the instruction is completed, execute another instruction for "n1" devices starting from

• Do not update (change) the contents of "n1" devices starting from

executed. If the contents are updated, the intended data may not be written to the buffer memories (BFM).

• Do not update (change) the contents of "n1" buffer memories (BFM) starting from the buffer memory No. "m2" while

the RBFM (FNC278) instruction is executed. If the contents are updated, the intended data may not be read.

Watchdog timer refresh

When WDT (FNC 07) instruction is not programmed, the value

of D8000 becomes valid during END processing.

Watchdog timer time: 300 ms

change while the RBFM (FNC278) instruction is executed. After

31 Data Transfer 3 – FNC276 to FNC279

31.1 FNC278 – RBFM / Divided BFM Read

while the WBFM (FNC279) instruction is

Fx3u series Fx3uc series