Appendix A-1-3 Precautions On Use Of (Built-In Usb) Programming Port - Mitsubishi Electric FX3G SERIES Programming Manual
Programmable controllers
Hide thumbs
Also See for FX3G SERIES:
- User manual (532 pages) ,
- Hardware manual (8 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
FX
/FX
/FX
Series Programmable Controllers
3G
3U
3UC
Programming Manual - Basic & Applied Instruction Edition
Appendix A-1-3
Precautions on Use of (Built-in USB) Programming Port
Make sure to set the contents described in this section when executing circuit monitor, device registration monitor,
program reading/writing, etc. in the FX
8.72A or later. For GX Developer prior to Ver. 8.72A, communication using the (built-in USB) programming port is not
available.
1. Installation of USB driver (GX Developer Ver. 8.72A or later)
It is necessary to install the USB driver to execute USB communication using the (built-in USB) programming port.
For the USB driver installation method and procedure, refer to the following manual.
2. Setting in GX Developer (Ver. 8.72A or later)
1)
Select [Online]
2)
Double-click [Serial] in [PC side I/F] to open "PC side I/F Serial setting" dialog box.
3)
Select "USB (Built-in port)".
A display screen is the example of Ver.8.72A.
4)
Click [OK] button to finish the setting.
PLC using the (built-in USB) programming port and GX Developer Ver.
3G
→
[Transfer setup...] to open "Transfer setup" dialog box.
Double-click it.
A Programming Tool Applicability and Version Upgrade History
A-1 Programming Tool Applicability
→ GX Developer Operating Manual (Startup)
Select "USB (Built-in port)"
31
32
33
34
35
36
37
38
A
B
899
Advertisement
Table of Contents
