Mitsubishi Electric FX3G SERIES Programming Manual page 132
Programmable controllers
Hide thumbs
Also See for FX3G SERIES:
- User manual (532 pages) ,
- Hardware manual (8 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
FX
/FX
/FX
Series Programmable Controllers
3G
3U
3UC
Programming Manual - Basic & Applied Instruction Edition
2. File register ↔ Data register <updating the same number registers by BMOV (FNC 15)
instruction>
When the same file register is specified for both
specifies the same-number register update mode and executes the following operation:
Inside built-in
memory or
memory cassette
Program
memory
Program/
comment
D1000
500 points ×
File register
14 blocks
[A]
maximum
(7000 points
maximum)
Inside built-in
memory or
memory cassette
Program
memory
Program/
comment
D1000
File
500 points ×
14 blocks
register
maximum
[A]
(7000 points
maximum)
• When updating the contents of a file register in the same-number register update mode, make sure that the file
register numbers at
specified by "n" does not exceed the file register area. If the number of transfer points exceeds the file register
area, an operation error occurs and the instruction is not executed.
• When
S
register area and if the number of transfer points is within the file register area also.
130
Inside system
RAM
D 0
Data
memory
Data register
D1100
D1100
Data register
Read
[B]
D1499
D1499
Data register
D7999
Inside system
RAM
D 0
Data
memory
Data
register
D1100
D1100
Data
Write
register
[B]
D1499
D1499
Data register
D7999
S
and
D
are equal to each other. Also make sure that the number of transfer points
and
D
are indexed, the instruction is executed if the actual device number is within the file
4.9 Data Register and File Register [D]
S
and
D
in BOMV (FNC 15) instruction, this instruction
Read
OFF
X002
FNC 15
D1100
BMOVP
Same file register number is specified.
•When X002 is set to ON while BMOV instruction direction
reverse flag M8024 is OFF, the contents of a file register are
transferred to the data register area [B] inside the data memory
as shown in the figure on the left.
Write
X001
ON
X003
FNC 15
D1100
BMOVP
Same file register number is specified.
M8001
Always OFF
during operation
•When X003 is set to ON while BMOV instruction direction
reverse flag M8024 is ON, the contents of a data register inside
the data memory are written to the file register area inside the
program memory as shown in the figure on the left.
4 Devices in Detail
BMOV
direction
M8024
inverse:
OFF
n
S
D
D1100
K400
BMOV
direction
M8024
inverse:
ON
n
S
D
D1100
K400
BMOV
M8024
direction
inverse:
OFF
Advertisement
Table of Contents
