Mitsubishi Electric FX3G SERIES Programming Manual page 410

Programmable controllers

Hide thumbs Also See for FX3G SERIES:

Table of Contents

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

1. When the command contact turns OFF

The current value [

2. Number of occupied devices

Two devices are occupied from a device specified as the teaching time

Make sure that these devices are not used in other controls for the machine.

: Teaching time

+1: Current value of the pressing and holding time

Program example

1. Writing the teaching time to 10 types of data registers

Suppose that the set value is written to D400 to D409 in advance.

+1] of the pressing and holding time is reset, and the teaching time

14 Handy Instruction – FNC 60 to FNC 69

10 timers to be set

Because the timers T0 to T9 are the 100 ms type, the actual

operating time (sec) is 1/10 of the teaching data.

Selecting a timer by a digital switch

An input to the 1-digit digital switch connected to X000 to

X003 is converted into binary format, and transferred to Z.

Measuring the teaching time

The time (sec) in which X010 is pressed and held is stored to

Recovery of the teaching time is detected.

Writing the set value of a timer

The teaching time (D300) is transferred to the register D400Z

for setting a timer selected by the digital switch.

14.5 FNC 64 – TTMR / Teaching Timer

will not change any

Fx3u series Fx3uc series