Mitsubishi Electric FX3G SERIES Programming Manual page 412

Programmable controllers

Hide thumbs Also See for FX3G SERIES:

Table of Contents

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

In the program shown below which turns OFF STMR instruction at the NC contact of

1. Handling of a specified timer

The timer number specified in this instruction cannot be used in other general circuits (such as OUT instruction).

If the timer number is used in other general circuits, the timer malfunctions.

2. Number of occupied devices

Four devices are occupied from a device specified in

Make sure that these devices are not used in other controls for the machine.

3. When the command contact is set to OFF

+3 are occupied.

: Occupied (, and can be used for off-delay timer). (Refer to the previous page.)

: Flicker (NO contact) which turns ON and OFF repeatedly at the interval of timer set value

: Flicker (NC contact) which turns ON and OFF repeatedly at the interval of timer set value

Off-delay timer

One-shot timer

Off-delay timer

One-shot timer

+3 will turn OFF after the set time.

Flicker (NO contact)

Flicker (NC contact)

+2 and the timer

14 Handy Instruction – FNC 60 to FNC 69

14.6 FNC 65 – STMR / Special Timer

+3, flicker is output to

are immediately reset.

Fx3u series Fx3uc series