Mitsubishi Electric FX3G SERIES Programming Manual page 549

Programmable controllers

Hide thumbs Also See for FX3G SERIES:

Table of Contents

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

Related devices

Instruction execution complete

Related instruction

SORT (FNC 69)

• Do not change the contents of operands and data during operation.

• To execute SORT2 instruction again, set the command input to OFF once, then ON again.

• Limitation in number of SORT2 instructions

Up to two SORT2 instructions can be simultaneously driven in a program.

• Writing during RUN is disabled for a circuit block including SORT2 instruction.

• When the same device is specified in

The source data is overwritten with the data acquired by sorting.

Pay close attention not to change the contents of

• Ensure that the sorted data does not overlap with the source data.

• Note that the 32-bit values [m1+1, m1] and [n+1, n] are valid when D or R is specified as "m1" or "n" in a 32-bit

instruction.

In the case of "DSORT2 D0 D50 K4 D100 R0", "m1" is [D51, D50], and "n" is [R1, R0].

→ For the instruction execution complete flag use method, refer to Subsection 6.5.2.

Descending order

Sort tabulated data

This instruction sorts a data table consisting of data (lines) and group data (columns) based on a specified

group data (column) sorted by line in ascending order. This instruction stores the group data (columns) in

serial devices.

19 Data Operation 2 – FNC140 to FNC149

19.7 FNC149 – SORT2 / Sort Tabulated Data 2

Turns ON when data sorting is completed.

Sorts data in the descending order when set to ON.

Sorts data in the ascending order when set to OFF.

until execution of SORT2 instruction is completed.

Fx3u series Fx3uc series