Mitsubishi Electric FX3G SERIES Programming Manual page 554
Programmable controllers
Hide thumbs
Also See for FX3G SERIES:
- User manual (532 pages) ,
- Hardware manual (8 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
FX
/FX
/FX
Series Programmable Controllers
3G
3U
3UC
Programming Manual - Basic & Applied Instruction Edition
2 : When using a special high-speed output adapter for the pulse output destination in an FX
direction signal must be used by the following table output.
When using a built-in transistor output for the pulse output destination in an FX
direction signal must use transistor output.
Special high-speed output adapter No.
No. 1 (1st unit)
No. 2 (2nd unit)
3 : "D .b" cannot be indexed with index registers (V and Z).
Explanation of function and operation
Command
input
FNC151
DVIT
Caution on writing during RUN
During RUN, avoid writing while the DVIT (FNC151) instruction is executed (that is, while a pulse is output).
Note that if writing is executed during RUN to a circuit block including the FNC151 instruction while pulses are output,
the PLC decelerates and stops pulse output.
Function change depending on the version
The functions of FNC151 instruction are changed depending on the version as shown in the table below.
Applicable version
FX
3U
Ver. 2.20 or later Ver. 1.30 or later
Ver. 2.20 or later Ver. 2.20 or later User interrupt mode
552
S
S
D
1
2
1
→ For explanation of the instruction and the contents of function change,
Item
FX
3UC
Interrupt input signal
specification function
20 Positioning Control – FNC150 to FNC159
20.2 FNC151 – DVIT / Interrupt Positioning
Pulse output
Rotation direction output
=Y000
D
1
=Y001
D
1
=Y002
D
1
=Y003
D
1
D
2
refer to the Positioning Control Edition.
Outline of function
When M8336 is set to ON, the interrupt input signal corresponding to Y000
to Y003 is changed to an input number (X000 to X007) specified by D8336.
When using a transistor output in the main unit, Y003 cannot be specified.
When "8" is specified by D8336 to the interrupt input signal corresponding
to Y000 to Y003 and M8336 is set to ON, the interrupt input signal is
changed to a special auxiliary relay. When this changed special auxiliary
relay is set to from OFF to ON in an input interrupt program, the PLC starts
the interrupt operation. When this function is used, however, the logic of
the interrupt input cannot be inverted.
In addition, when using a transistor output in the main unit, Y003 cannot be
specified.
PLC, the rotation
3U
/FX
PLC, the rotation
3U
3UC
D
=Y004
2
D
=Y005
2
D
=Y006
2
D
=Y007
2
Advertisement
Table of Contents
