Mitsubishi Electric FX3G SERIES Programming Manual page 801

Programmable controllers

Hide thumbs Also See for FX3G SERIES:

Table of Contents

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

Example of flows with parallel branches and recombination

When the parts A, B and C are processed in parallel and then assembled, flows having parallel branches and

recombination are used.

1. Example of pushbutton type crosswalk

A pushbutton type crosswalk shown in the figure below can be expressed in flows having parallel branches and

recombination.

Y003: Green Y002: Yellow Y001: Red

The SFC program for a pushbutton type crosswalk is as shown below. In this example, a partial flow (jump to a state

relay located in an upper position) is repeated for blinking the green lamp on the crosswalk.

• When the PLC mode is changed from STOP to RUN, the initial state relay S0 turns ON. Normally, the green lamp

is ON for the road and the red lamp is ON for the sidewalk.

• When the crossing button X000 or X001 is pressed, the state relay S21 specifies "road: green" and the state relay

S30 specifies "sidewalk: red". The signal lamp status is not changed.

• Thirty seconds later, the yellow lamp turns ON for the road. Ten seconds later after that, the red lamp turns ON for

• When the timer T2 (5 seconds) reaches timeout after that, the green lamp turns ON for the sidewalk.

• Fifteen seconds later, the green lamp starts to blink for the sidewalk. (S32 turns OFF the green lamp, and S33

turns ON the green lamp.)

• While the green lamp is blinking, S32 and S33 turn ON and OFF repeatedly. When the counter C0 (set value: 5)

turns ON, S34 turns ON. Five seconds after the red lamp turns ON for the sidewalk, the signal lamps return to the

initial state.

• Even if the crossing button X000 or X001 is pressed in the middle of operation, the pressing is ignored.

35 SFC Program and Step Ladder

35.2 Step Ladder

Fx3u series Fx3uc series