Counter Interrupt - Interrupt Triggered By Counting Up Of High-Speed Counter - Mitsubishi Electric FX3G SERIES Programming Manual
Programmable controllers
Hide thumbs
Also See for FX3G SERIES:
- User manual (532 pages) ,
- Hardware manual (8 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
FX
/FX
/FX
Series Programmable Controllers
3G
3U
3UC
Programming Manual - Basic & Applied Instruction Edition
36.6
Counter Interrupt - Interrupt Triggered by Counting Up of High-Speed
Counter
1. Outline
This type of interrupt utilizes the current value of a high-speed counter.
2. Application
This type of interrupt is used together with the comparison set instruction DHSCS (FNC 53). When the current value
of a high-speed counter reaches the specified value, an interrupt routine is executed.
3. Basic program (programming procedure)
Step
0
M8000
RUN
monitor
When counter interrupt is specified
Interrupt
pointer
I010
*1.
When the comparison value specified by a data register, etc. is changed, the current value is actually changed
to the specified value when END instruction is executed.
4. Number and operation of (six) counter interrupt pointers
I 0
0
Counter interrupt pointer (1 to 6)
Pointer No.
I010,I020,I030,I040,I050,I060
*1.
Cleared when the PLC mode is changed from RUN to STOP.
5. When setting an interrupt output (Y or M) to ON or OFF using a high-speed counter
When only controlling the ON/OFF status of an output relay (Y) or auxiliary relay (M) according to the current value of
a high-speed counter, a required program can be easily created using DHSCS (FNC 53), DHSCR (FNC 54) or DHSZ
(FNC 55) instruction.
6. Cautions
1)
Pointer number
Pointer numbers cannot overlap with each other.
2)
Disabling interrupts
When the special auxiliary relay M8059 is set to ON in a program, all counter interrupts are disabled.
816
FNC 04
EI
C255
K2,147,483,647
FNC 53
DHSCS K1000 C255
I010
*1
Interrupt pointer
number is
FNC 06
FEND
specified
Interrupt routine
(interrupt program)
FNC 03
Interrupt return
IRET
END
Interrupt disable flag
*1
M8059
36 Interrupt Function and Pulse Catch Function
36.6 Counter Interrupt - Interrupt Triggered by Counting Up of High-Speed Counter
Main program
Interrupts are enabled after EI (FNC 04)
instruction.
The main program is described.
The coil of a high-speed counter is driven, and
an interrupt pointer is specified in DHSCS (FNC
53) instruction.
When the current value of C255 changes from
"999" to "1000", the interrupt routine is executed.
For an interrupt routine use example, refer to the
input interrupt function described in the
preceding section.
Advertisement
Table of Contents
