Table of Contents
Advertisement
Appendix C
Supporting and Using Additional CLI Access Options
Figure C-6
PXM-UI-S3/B
back card
PXM
UI-S3/B
C
P
P2
S
P
L
A
N
1
L
A
N
2
E
X
T
C
L
K
1
E
X
T
C
L
K
2
A
L
A
R
M
Before you can manage the switch using the dial-up interface, you must first assign an IP address to the
maintenance port on the switch. This maintenance port is located on the PXM back card. For more
information on physically connecting a modem to the maintenance port, refer to the Cisco MGX 8850
(PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Hardware Installation
Guide, Releases 2 Through 5.
To configure an IP address on the switch maintenance port, use the following procedure.
Establish a CLI management session using a username with SUPER_GP privileges. The default user
Step 1
name and password for this level are superuser, <superuser>.
Verify that the IP address is not already configured by entering the following command:
Step 2
mgx8850a.7.PXM.a> dspipif sl0
Note
In the IP Interface Configuration Table, look for an Internet address entry under the sl0 entry. (You may
need to press Enter to see this.) If an IP address is configured, you can use that address and skip the rest
of this procedure. However, if the address has not been entered or is incompatible with your network,
you must configure a valid IP address as described in the next step.
To set the IP address for the maintenance port, enter the ipifconfig command using the following format:
Step 3
mgx8850a.7.PXM.a> ipifconfig sl0 <IP_Addr> <netmask Mask>
Replace <IP_Addr> with the IP address you want this port to use, and replace <Mask> with the network
mask used on this network.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Hardware Required for Dial-up Connections on a PXM1E UI-S3/B Back Card
Modem
P1
Modem
Workstation
If you omit the sl0 option, the switch displays the configuration for all switch IP interfaces: the
ATM interface (atm0), the PXM LAN port interface (lnPci0), and the PXM maintenance port
interface (sl0). Note that the address for each interface must be unique.
Setting Up Dial-Up Connections
C-7
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco MGX 8850 (PXM1E/PXM45)
Related Products for Cisco MGX 8850 (PXM1E/PXM45)
- Cisco 887V - Integrated Services Router
- Cisco 880 Series
- Cisco 881-SEC-K9 - 881 Ethernet Security Router
- Cisco 881G-K9 - 881 EN Security Router
- Cisco 886G-K9 - 886 ADSL2/2+ Annex B Router
- Cisco Cisco 881
- Cisco 881G-G-K9 - 881 Fast EN Security Router Wireless
- Cisco 888GW-GN-E-K9 - 888 G.SHDSL Wireless Router