Applying Power To The Power Converter; Connecting The Switch To The Ac-Input Power Supply; Attaching The Power Supply To The Switch; Installing The Ac-Input Power Supply On A Din Rail, Wall, Or Rack Adapter - Cisco IE 3000 Hardware Installation Manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (170 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Connecting the Switch to the AC-Input Power Supply
Applying Power to the Power Converter
Move the circuit breaker for the AC outlet or the DC control circuit to the on position.
The LED on the power converter front panel is green when the unit is operating normally. The LED is
off when the unit is not powered or is not operating normally. After the power is connected, the switch
automatically begins the power-on self- test (POST), a series of tests that verifies that the switch
functions properly. For instructions on how to interpret POST results, see the
section on page
Connecting the Switch to the AC-Input Power Supply
The Cisco IE 3000 switch can be used with an optional AC-input power supply (PWR-IE50W-AC or
PWR-IE50W-AC-IEC).
These sections describe the steps required to connect the switch to the AC-input power supply:
•
•
•
•
Attaching the Power Supply to the Switch
Follow these steps to connect the AC-input power supply to the switch:
Remove the left side panel of the switch by firmly grasping both sides of it in the middle and pulling it
Step 1
outward. If necessary, use a screwdriver to open the side panel. See
to remove the switch side panel.
Push the upper modules latches (at the top of the switch and the AC-input power supply) up and the lower
Step 2
module latches (at the bottom of the switch and the AC-input power supply) down. See
an illustration showing the latches operation.
Step 3
Put the two modules together so that the AC-input power supply fits in the switch recess.
Step 4
Push the upper module latches down and the lower module latches up to secure the AC-input power
supply to the switch.
Installing the AC-input Power Supply on a DIN Rail, Wall, or Rack Adapter
You install the AC-input power supply on a DIN rail, wall, or rack as you would a switch module. You
should first attach the AC-input power supply to the switch and then install the entire switch assembly
on the DIN rail, wall, or rack adapter. For more information, see the
Switch" section on page
"Installing the Switch on the Wall" section on page
on page
Cisco IE 3000 Switch Hardware Installation Guide
2-56
2-25.
Attaching the Power Supply to the Switch, page 2-56
Installing the AC-input Power Supply on a DIN Rail, Wall, or Rack Adapter, page 2-56
Connecting the DC Power Clip, page 2-57
Connecting the AC-Input Power Supply to an AC Power Source, page 2-57
2-56, the
2-33.
"Installing the Switch on a DIN Rail" section on page
2-31, or the
Chapter 2
Switch Installation
"Verify POST Results"
Figure 2-38
for a illustration of how
Figure 2-39
"Attaching the Power Supply to the
"Installing the Switch in a Rack" section
for
2-27, the
- Quick Links:
- Power Converter (Optional)
Hide quick links:
Advertisement
Table of Contents
