Configuring The Switch Module; Assigning The Switch Module Ip Address - Cisco Catalyst 3110G Getting Started Manual

For ibm bladecenter

Hide thumbs Also See for Catalyst 3110G:

Table of Contents

Configuring the Switch Module

When you first set up the switch module, you should use the blade enclosure advanced Management

Module (aMM) to enter the initial IP information and the Cisco device manager Express Setup screen

to configure the switch module password and Telnet access. You can then access the switch module

through the IP address for further configuration.

Before running the setup procedures, observe these cautions:

Do not connect devices to the switch module external ports until you have completed the

Caution

setup procedures and your configuration matches that of the upstream network.

For Catalyst 3110G and 3110X switch modules, make sure that no StackWise Plus cables

Caution

are connected to the switch module when running the setup procedures. If StackWise Plus

cables are connected, you cannot access the switch module by using the aMM.

If you have already connected StackWise Plus cables, remove the cables, and then restart

the switch modules by removing and inserting the modules in the blade enclosure.

To complete this procedure, you will need this information from your system administrator:

• Static IP address

• Default gateway IP address

Follow these steps:

Step 1

Connect and log on to the aMM as described in the IBM BladeCenter Advanced Management

Module User's Guide.

The aMM web interface refers to the switch module as the I/O module.

Note

Table of Contents

Show Quick Links

Table of Contents

Catalyst 3110x Catalyst 3012