Vlan Groups - Cisco 500 series Administration Manual
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
VLAN Management
VLAN Groups
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
VLAN Groups
Cisco 500 Series Stackable Managed Switch Administration Guide
GVRP must be activated globally as well as on each port. When it is activated, it
transmits and receives GARP Packet Data Units (GPDUs). VLANs that are defined
but not active are not propagated. To propagate the VLAN, it must be up on at least
one port.
By default, GVRP is disabled globally and on ports.
Defining GVRP Settings
To define GVRP settings for an interface:
Click VLAN Management > GVRP Settings. The GVRP Settings page is
displayed.
Select GVRP Global Status to enable GVRP globally.
Click Apply to set the global GVRP status.
Select an interface type (Port or LAG), and click Go to display all interfaces of that
type.
To define GVRP settings for a port, select it, and click Edit. The
page is displayed.
Enter the values for the following fields:
•
Interface—Select the interface (Port or LAG) to be edited.
•
GVRP State—Select to enable GVRP on this interface.
•
Dynamic VLAN Creation—Select to enable Dynamic VLAN Creation on this
interface.
•
GVRP Registration—Select to enable VLAN Registration using GVRP on
this interface.
Click Apply. GVRP settings are modified, and written to the Running Configuration
file.
VLAN groups are used for load balancing of traffic on a Layer 2 network.
13
Edit GVRP Setting
214
Hide quick links:
Advertisement
Table of Contents
