Cisco 500 series Administration Manual page 463
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
RIP
How RIP Operates on the Device
Cisco 500 Series Stackable Managed Switch Administration Guide
The following illustrates the configuration of the metric offset for various
interfaces, based on port speed.
Configuring the Offset (Based on Port Speed)
Router rD can send data to rA via rB or rC. Since rC only supports Fast Ethernet
(FE) ports, and rB supports Gigabit Ethernet (GE) ports, the path cost from router
rD to router rA is higher via router rC (additional 4 to the cost path) as opposed to
the path via router rB (additional 2 to the cost path), Therefore, forwarding traffic
via routing rB is preferred. To achieve this, you configure a different offset (metric
value) on each interface based on its line speed.
See
Offset Configuration
Passive Mode
Transmission of routing update messages over a specific IP interface can be
disabled. In this case, the router is passive, and only receives the updated RIP
information on this interface. By default, transmission of routing updates on an IP
interface is enabled.
See
RIP Settings on an IP Interface
for more information.
for more information.
27
463
Hide quick links:
Advertisement
Table of Contents
