Cisco 12404 Installation And Configuration Manual page 163
Internet router
Hide thumbs
Also See for 12404:
- Unpacking instructions manual (18 pages) ,
- Technical specifications (31 pages) ,
- Datasheet (9 pages)
Table of Contents
Advertisement
Copying a Cisco IOS Software Image
Flash Memory Card Space
Step 1
Step 2
Step 3
Step 4
Cisco 12404 Internet Router Installation and Configuration Guide
3-81
This procedure assumes that there is sufficient space on the old Flash memory
card inserted in slot 0 for both the new Cisco IOS software image and the old
image. If there is not enough space for both images on the old Flash memory card,
use the delete command to delete files from the old Flash memory card, but do
not delete the image.old file. After deleting files, use the squeeze command to
remove the deleted files from the old Flash memory card permanently. (For
information on the squeeze command, see the
Commands, page
3-74.)
If the two files still will not fit on the Flash memory card in slot 0 after you delete
files and use the squeeze command, remove this card, place it in an antistatic bag
for ESD protection, and store it in a safe place. Insert the Flash memory card
containing image.new in slot 0. Proceed to
enter the command boot system flash slot0:image.new to designate the file
image.new as the new default Cisco IOS software boot image.
To copy a bootable Cisco IOS software image between Flash memory cards,
follow these steps:
Boot the router. For this example, the file named image.boot is the default boot
image.
Enter the enable command to enter privileged EXEC mode as follows:
Filo> enable
Password: <password>
Filo#
Insert the new Flash memory card in slot 1.
Enter the following command to copy the file image.new in slot 1 to the Flash
memory card in PCMCIA slot 0.
Perform this step only if sufficient space is available on the Flash memory
Note
card in slot 0 to hold both the new image and the old image already
resident on the Flash memory card.
Filo# copy slot1:image.new slot0:image.new
Chapter 3
Installing the Cisco 12404 Internet Router
Flash Memory Console
Step 5
in the following procedure and
OL-11636-01
Advertisement
Table of Contents
Troubleshooting
