hit counter script

Interface Range - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:
Table of Contents

Advertisement

Chapter 2
Catalyst 2960 Switch Cisco IOS Commands

interface range

Use the interface range global configuration command to enter interface range configuration mode and
to execute a command on multiple ports at the same time. Use the no form of this command to remove
an interface range.
Syntax Description
port-range
macro name
Defaults
This command has no default setting.
Command Modes
Global configuration
Command History
Release
12.2(25)FX
Usage Guidelines
When you enter interface range configuration mode, all interface parameters you enter are attributed to
all interfaces within the range.
For VLANs, you can use the interface range command only on existing VLAN switch virtual interfaces
(SVIs). To display VLAN SVIs, enter the show running-config privileged EXEC command. VLANs not
displayed cannot be used in the interface range command. The commands entered under interface
range command are applied to all existing VLAN SVIs in the range.
All configuration changes made to an interface range are saved to NVRAM, but the interface range itself
is not saved to NVRAM.
You can enter the interface range in two ways:
All interfaces in a range must be the same type; that is, all Fast Ethernet ports, all Gigabit Ethernet ports,
all EtherChannel ports, or all VLANs. However, you can define up to five interface ranges with a single
command, with each range separated by a comma.
78-16882-01
interface range {port-range | macro name}
no interface range {port-range | macro name}
Port range. For a list of valid values for port-range, see the "Usage Guidelines"
section.
Specify the name of a macro.
Modification
This command was introduced.
Specifying up to five interface ranges
Specifying a previously defined interface-range macro
Catalyst 2960 Switch Command Reference
interface range
2-87

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents