Srr-Queue Bandwidth Limit - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

srr-queue bandwidth limit

Use the srr-queue bandwidth limit interface configuration command to limit the maximum output on

a port. Use the no form of this command to return to the default setting.

Syntax Description

The port is not rate limited and is set to 100 percent.

Command Modes

Interface configuration

Command History

Usage Guidelines

If you configure this command to 80 percent, the port is idle 20 percent of the time. The line rate drops

to 80 percent of the connected speed. These values are not exact because the hardware adjusts the line

rate in increments of six.

The egress queue default settings are suitable for most situations. You should change them only when

you have a thorough understanding of the egress queues and if these settings do not meet your quality

of service (QoS) solution.

This example shows how to limit a port to 800 Mbps:

Switch(config)# interface gigabitethernet0/1

Switch(config-if)# srr-queue bandwidth limit 80

You can verify your settings by entering the show mls qos interface [interface-id] queueing privileged

EXEC command.

Catalyst 2960 Switch Command Reference

srr-queue bandwidth limit weight1

no srr-queue bandwidth limit

Percentage of the port speed to which the port should be limited. The range is 10 to 90.

Modification

This command was introduced.

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

Show Quick Links

Table of Contents