Cisco Catalyst 2960 Command Reference Manual page 511
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Command History
Release
12.2(25)FX
Usage Guidelines
A secure port has the following limitations:
•
•
•
•
•
•
•
•
•
A security violation occurs when the maximum number of secure MAC addresses are in the address table
and a station whose MAC address is not in the address table attempts to access the interface or when a
station whose MAC address is configured as a secure MAC address on another secure port attempts to
access the interface.
If you enable port security on a voice VLAN port and if there is a PC connected to the IP phone, you
should set the maximum allowed secure addresses on the port to more than 1.
When a secure port is in the error-disabled state, you can bring it out of this state by entering the
errdisable recovery cause psecure-violation global configuration command, or you can manually
re-enable it by entering the shutdown and no shut down interface configuration commands.
Setting a maximum number of addresses to one and configuring the MAC address of an attached device
ensures that the device has the full bandwidth of the port.
When you enter a maximum secure address value for an interface, this occurs:
•
•
78-16882-01
Modification
This command was introduced.
A secure port can be an access port or a trunk port; it cannot be a dynamic access port.
A secure port cannot be a protected port.
A secure port cannot be a destination port for Switched Port Analyzer (SPAN).
A secure port cannot belong to a Fast EtherChannel or Gigabit EtherChannel port group.
You cannot configure static secure or sticky secure MAC addresses in the voice VLAN.
When you enable port security on an interface that is also configured with a voice VLAN, you must
set the maximum allowed secure addresses on the port to two plus the maximum number of secure
addresses allowed on the access VLAN. When the port is connected to a Cisco IP Phone, the Cisco
IP Phone requires up to two MAC addresses. The Cisco IP Phone address is learned on the voice
VLAN and might also be learned on the access VLAN. Connecting a PC to the Cisco IP Phone
requires additional MAC addresses.
Voice VLAN is supported only on access ports and not on trunk ports.
When you enter a maximum secure address value for an interface, if the new value is greater than
the previous value, the new value overrides the previously configured value. If the new value is less
than the previous value and the number of configured secure addresses on the interface exceeds the
new value, the command is rejected.
The switch does not support port security aging of sticky secure MAC addresses.
If the new value is greater than the previous value, the new value overrides the previously configured
value.
If the new value is less than the previous value and the number of configured secure addresses on
the interface exceeds the new value, the command is rejected.
switchport port-security
Catalyst 2960 Switch Command Reference
2-483
Hide quick links:
Advertisement
Table of Contents
