Table of Contents
Advertisement
Completing the Configuration Setup Wizard
Step 4
Connect a straight-through Category 5 Ethernet cable to a 10/100/1000 Ethernet port on the switch front panel
and to the Ethernet port on the PC.
Step 5
Verify that the LEDs on both Ethernet ports are green.
Step 6
Wait 30 seconds.
Step 7
Enter the IP address 10.0.0.1 or 10.0.0.3 in the Web browser, on your PC. On Cisco Catalyst 2960-X and
2960-XR switches, if you have connected to a downlink access port, enter the IP address 10.0.2.1.
Step 8
Enter the following default credentials: username: cisco, password: cisco and press Enter.
The Configuration Setup wizard is displayed.
Completing the Configuration Setup Wizard
Completing the Configuration Setup Wizard enables you to set up your device with the minimum configuration
required to enable traffic to pass through the network. To achieve this, you must complete the following setup
tasks as you proceed with the Configuration Setup Wizard.
• Basic Device Settings
• Interfaces
• Layer 3 Settings
• Advanced Device Settings
For more information on the configuration steps involved in completing the Configuration Setup Wizard, see
User Guide for Cisco Configuration Professional for Catalyst .
Configuring the Switch Using the CLI
Accessing the CLI Through the Console Port
You can access the CLI on a configured or unconfigured switch by connecting the RJ-45 console port or USB
console port of the switch to your PC or workstation and accessing the switch through a terminal emulation
program.
Cisco Catalyst 2960-L Series 24-Port and 48-Port Switch Hardware Installation Guide
52
Configuring the Switch
Hide quick links:
Advertisement
Table of Contents
