Destination Port - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Understanding SPAN and RSPAN
Destination Port
Each local SPAN session or RSPAN destination session must have a destination port (also called a
monitoring port) that receives a copy of traffic from the source ports or VLANs and sends the SPAN
packets to the user, usually a network analyzer.
A destination port has these characteristics:
•
•
Exception. When QoS is configured on the SPAN destination port, QoS takes effect immediately.
Note
•
•
•
•
•
•
•
•
•
•
•
Local SPAN and RSPAN destination ports behave differently regarding VLAN tagging and
encapsulation:
•
•
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
27-8
For a local SPAN session, the destination port must reside on the same switch stack as the source
port. For an RSPAN session, it is located on the switch containing the RSPAN destination session.
There is no destination port on a switch or switch stackrunning only an RSPAN source session.
When a port is configured as a SPAN destination port, the configuration overwrites the original port
configuration. When the SPAN destination configuration is removed, the port reverts to its previous
configuration. If a configuration change is made to the port while it is acting as a SPAN destination
port, the change does not take effect until the SPAN destination configuration had been removed.
If the port was in an EtherChannel group, it is removed from the group while it is a destination port.
It can be any Ethernet physical port.
It cannot be a secure port.
It cannot be a source port.
It cannot be an EtherChannel group or a VLAN.
It can participate in only one SPAN session at a time (a destination port in one SPAN session cannot
be a destination port for a second SPAN session).
When it is active, incoming traffic is disabled. The port does not transmit any traffic except that
required for the SPAN session. Incoming traffic is never learned or forwarded on a destination port.
If ingress traffic forwarding is enabled for a network security device, the destination port forwards
traffic at Layer 2.
It does not participate in any of the Layer 2 protocols (STP, VTP, CDP, DTP, PagP).
A destination port that belongs to a source VLAN of any SPAN session is excluded from the source
list and is not monitored.
The maximum number of destination ports in a switch is 64.
For local SPAN, if the encapsulation replicate keywords are specified for the destination port, these
packets appear with the original encapsulation (untagged or IEEE 802.1Q). If these keywords are
not specified, packets appear in the untagged format. Therefore, the output of a local SPAN session
with encapsulation replicate enabled can contain a mixture of untagged or IEEE 802.1Q-tagged
packets.
For RSPAN, the original VLAN ID is lost because it is overwritten by the RSPAN VLAN
identification. Therefore, all packets appear on the destination port as untagged.
Chapter 27
Configuring SPAN and RSPAN
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
