Vlan Configuration Mode - Cisco Catalyst 3750 Metro Command Reference Manual
Hide thumbs
Also See for Catalyst 3750 Metro:
- Product support bulletin (6 pages) ,
- Reference manual (58 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 3750 Metro Switch Cisco IOS Commands
Examples
This example shows how to create a local SPAN session 1 to monitor both sent and received traffic on
source port Gigabit Ethernet 1 to destination port Gigabit Ethernet 2:
Switch(config)# monitor session 1 source interface gigabitethernet1/0/1 both
Switch(config)# monitor session 1 destination interface gigabitethernet1/0/2
This example shows how to delete a destination port from an existing local SPAN session:
Switch(config)# no monitor session 2 destination gigabitethernet1/0/2
This example shows how to limit SPAN traffic in an existing session only to specific VLANs:
Switch(config)# monitor session 1 filter vlan 100 - 110
This example shows how to configure RSPAN source session 1 to monitor multiple source interfaces and
to configure the destination RSPAN VLAN 900.
Switch(config)# monitor session 1 source interface fastethernet1/0/10 , fastethernet1/0/12
Switch(config)# monitor session 1 source interface fastethernet1/0/2 rx
Switch(config)# monitor session 1 source interface port-channel 2 tx
Switch(config)# monitor session 1 destination remote vlan 900
Switch(config)# end
This example shows how to configure an RSPAN destination session 10 in the switch receiving the
monitored traffic.
Switch(config)# monitor session 10 source remote vlan 900
Switch(config)# monitor session 10 destination interface fastethernet1/0/10
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a
security device that supports 802.1Q encapsulation. Egress traffic replicates the source; ingress traffic
uses 802.1Q encapsulation.
Switch(config)# monitor session 2 destination interface fastethernet1/0/5 encapsulation
replicate ingress dot1q vlan 5
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a
security device that does not support encapsulation. Egress traffic and ingress traffic are untagged.
Switch(config)# monitor session 2 destination interface fastethernet1/0/5 ingress untagged
vlan 5
You can verify your settings by entering the show monitor privileged EXEC command. You can view
SPAN and RSPAN configuration on the switch by entering the show running-config privileged EXEC
command. SPAN information appears near the end of the output.
Related Commands
Command
remote-span
show monitor
show running-config
OL-9645-10
Description
Configures an RSPAN VLAN in vlan configuration mode.
Displays SPAN and RSPAN session information.
Displays the operating configuration. For syntax information, use
this link to the Cisco IOS Release 12.2 Command Reference listing
page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_co
mmand_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to
navigate to the command.
Catalyst 3750 Metro Switch Command Reference
monitor session
2-319
Advertisement
Table of Contents
