Cisco Catalyst 4500 Series Software Configuration Manual page 1867
Cisco ios xe release 3.9.xe and cisco ios release 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages) ,
- Command reference manual (1230 pages)
Table of Contents
Advertisement
Chapter 75
Configuring Ethernet OAM and CFM
Command
Step 1
configure terminal
Step 2
ethernet cfm alarm notification {all |
error-xcon | mac-remote-error-xcon | none |
remote-error-xcon | xcon}
Step 3
ethernet cfm alarm delay value
Step 4
ethernet cfm alarm reset value
Step 5
ethernet cfm logging alarm ieee
Step 6
interface interface-id
Step 7
ethernet cfm mep domain domain-name mpid
identifier vlan vlan-id
Step 8
alarm notification {all | error-xcon |
mac-remote-error-xcon | none |
remote-error-xcon | xcon}
{
Step 9
alarm
delay value | reset value}
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Purpose
Enters global configuration mode.
Globally enables Ethernet CFM fault alarm notification for
the specified defects:
•
all—report all defects.
•
error-xcon—Report only error and connection
defects.
•
mac-remote-error-xcon—Report only MAC-address,
remote, error, and connection defects.
none—Report no defects.
•
remote-error-xcon—Report only remote, error, and
•
connection defects.
xcon—Report only connection defects.
•
(Optional) Sets a delay period before a CFM fault alarm is
sent. The range is 2500 to 10000 milliseconds (ms). The
default is 2500 ms.
(Optional) Specifies the time period before the CFM fault
alarm is reset. The range is 2500 to 10000 milliseconds
(ms). The default is 10000 ms.
Configures the switch to generate system logging messages
for the alarms.
(Optional) Specifies an interface to configure, and enter
interface configuration mode.
Configures maintenance end points for the domain, and
enter ethernet cfm interface mep mode.
domain domain-name—Specify the name of the
•
created domain.
mpid identifier—Enter a maintenance end point
•
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to 8191.
vlan vlan-id—Enter the service provider VLAN ID or
•
IDs as a VLAN-ID (1 to 4094), a range of VLAN-IDs
separated by a hyphen, or a series of VLAN IDs
separated by comma.
(Optional) Enables Ethernet CFM fault alarm notification
for the specified defects on the interface.
Note
The Ethernet CFM interface MEP alarm
configuration takes precedence over the global
configuration.
(Optional) Sets an alarm delay period or a reset period.
Note
The Ethernet CFM interface MEP alarm
configuration takes precedence over the global
configuration.
Configuring Ethernet CFM
75-17
Advertisement
Chapters
Table of Contents
Troubleshooting
