Table of Contents
Advertisement
Chapter 7
Administering the Switch
Displaying the NTP Configuration
You can use two privileged EXEC commands to display NTP information:
•
•
For detailed information about the fields in these displays, see the Cisco IOS Configuration
Fundamentals Command Reference, Release 12.2.
Configuring Time and Date Manually
If no other source of time is available, you can manually configure the time and date after the system is
restarted. The time remains accurate until the next system restart. We recommend that you use manual
configuration only as a last resort. If you have an outside source to which the switch can synchronize,
you do not need to manually set the system clock.
These sections contain this configuration information:
•
•
•
•
Setting the System Clock
If you have an outside source on the network that provides time services, such as an NTP server, you do
not need to manually set the system clock.
Beginning in privileged EXEC mode, follow these steps to set the system clock:
Command
Step 1
clock set hh:mm:ss day month year
or
clock set hh:mm:ss month day year
This example shows how to manually set the system clock to 1:32 p.m. on July 23, 2001:
Switch# clock set 13:32:00 23 July 2001
OL-23389-01
show ntp associations [detail]
show ntp status
Setting the System Clock, page 7-11
Displaying the Time and Date Configuration, page 7-12
Configuring the Time Zone, page 7-12
Configuring Summer Time (Daylight Saving Time), page 7-13
Purpose
Manually set the system clock using one of these formats.
For hh:mm:ss, specify the time in hours (24-hour format), minutes,
•
and seconds. The time specified is relative to the configured time
zone.
•
For day, specify the day by date in the month.
•
For month, specify the month by name.
•
For year, specify the year (no abbreviation).
Catalyst 2928 Switch Software Configuration Guide
Managing the System Time and Date
7-11
Advertisement
Table of Contents
Troubleshooting
