Table of Contents
Advertisement
Configuring Port-Based Traffic Control
This chapter describes how to configure the port-based traffic control features on the Catalyst 2928
switch.
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release.
This chapter consists of these sections:
•
•
•
•
•
Configuring Storm Control
These sections contain this conceptual and configuration information:
•
•
•
•
Understanding Storm Control
Storm control prevents traffic on a LAN from being disrupted by a broadcast, multicast, or unicast storm
on one of the physical interfaces. A LAN storm occurs when packets flood the LAN, creating excessive
traffic and degrading network performance. Errors in the protocol-stack implementation, mistakes in
network configurations, or users issuing a denial-of-service attack can cause a storm.
Storm control (or traffic suppression) monitors packets passing from an interface to the switching bus
and determines if the packet is unicast, multicast, or broadcast. The switch counts the number of packets
of a specified type received within the 1-second time interval and compares the measurement with a
predefined suppression-level threshold.
OL-23389-01
Configuring Storm Control, page 22-1
Configuring Protected Ports, page 22-6
Configuring Port Blocking, page 22-7
Configuring Port Security, page 22-8
Displaying Port-Based Traffic Control Settings, page 22-18
Understanding Storm Control, page 22-1
Default Storm Control Configuration, page 22-3
Configuring Storm Control and Threshold Levels, page 22-3
Configuring Small-Frame Arrival Rate, page 22-5
C H A P T E R
Catalyst 2928 Switch Software Configuration Guide
22
22-1
Advertisement
Table of Contents
Troubleshooting
