Table of Contents
Advertisement
Figure 5-6
(see
Figure
Figure 6-4
TORX screw
TORX screw
The T-10 TORX driver tool and a 1/4-inch flathead screwdriver are used to remove and install the cable
bar clamp on the UCH, and loosen the line card captive screws.
The Cisco RFGW-10 UEQAM coaxial cable interface uses 75-ohm precision miniature video cable
bundled cables terminated to 75-ohm MCX connectors. The cables come in bundles of five that will fit
into the provided rear RF cable-management bracket. (See
Note
The Cisco RFGW-10 UEQAM coaxial termination must use quad-shielded 75-ohm precision miniature
video cable.
Note
Other bundle types exist for quad-shielded 75-ohm precision miniature video cable but only the five
bundle will fit into the provided cable management bracket and allow for easy removal of the RF Switch
Cards.
Cisco RF Gateway 10 Hardware Installation Guide
6-4
shows the rear of the Cisco RFGW-10 UEQAM with 12 RF switch cards installed with UCH2
6-4).
Universal Cable Holder UCH2
Red line
Lock bar
Lead
screw
Chapter 6
Small pin
Cutout
Screws into
faceplate
Cutout
Large pin
Shroud
Figure
6-5.)
Cabling the Cisco RFGW-10 UEQAM
OL-16264-04
Advertisement
Table of Contents
