Table of Contents
Advertisement
Cabling the Supervisor Engine
Maximum Cable Distances
Table 6-5
Table 6-5
Maximum Cable Distances
Transceiver Speed (Mbps)
10
10
100
100
100
Attaching Module Interface Cables
The connector types used to attach interface cables to the Supervisor Engine are:
•
•
Figure 6-14
Pin 1
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
Warning
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when
connecting cables. Statement 1021
Note
Always keep caps and plugs on the fiber-optic connectors on the cable and the switch when they are not
in use.
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Cisco RF Gateway 10 Hardware Installation Guide
6-18
shows the maximum cable distances for transceiver speed and cable type.
Cable Type
Category 3 UTP
MMF
Category 5 UTP
MMF
MMF
RJ-45 (see
Figure
6-14)
SC-Type Fiber-Optic (see
RJ-45 Connector
Pin 8
Duplex Mode
Half or full
Half or full
Half or full
Half
Full
Figure
6-15)
RJ-45 (both ends)
Chapter 6
Cabling the Cisco RFGW-10 UEQAM
Maximum Distance Between
Stations
328 ft (100 m)
1.2 miles (2 km)
328 ft (100 m)
1312 ft (400 m)
1.2 miles (2 km)
OL-16264-04
Advertisement
Table of Contents
