Encapsulation Types - Cisco Catalyst 3750 Software Configuration Manual
Metro switch
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Hardware installation manual (231 pages) ,
- Message manual (120 pages)
Table of Contents
Advertisement
Configuring VLAN Trunks
Table 10-4 Layer 2 Interface Modes
Mode
switchport mode access
switchport mode dynamic auto
switchport mode dynamic
desirable
switchport mode trunk
switchport nonegotiate
switchport mode dot1q-tunnel
Encapsulation Types
Table 10-5
Table 10-5 Ethernet Trunk Encapsulation Types
Encapsulation
switchport trunk encapsulation isl
switchport trunk encapsulation dot1q
switchport trunk encapsulation negotiate Specifies that the interface negotiate with the neighboring interface to become
switchport trunk dot1q ethertype value
The switch does not support Layer 3 trunks; you cannot configure subinterfaces or use the encapsulation
Note
keyword on Layer 3 interfaces. The switch does support Layer 2 trunks and Layer 3 VLAN interfaces,
which provide equivalent capabilities.
The trunking mode, the trunk encapsulation type, and the hardware capabilities of the two connected
interfaces determine whether a link becomes an ISL or 802.1Q trunk.
Catalyst 3750 Metro Switch Software Configuration Guide
10-18
Function
Puts the interface (access port) into permanent nontrunking mode and negotiates to
convert the link into a nontrunk link. The interface becomes a nontrunk interface
regardless of whether or not the neighboring interface is a trunk interface.
Makes the interface able to convert the link to a trunk link. The interface becomes a trunk
interface if the neighboring interface is set to trunk or desirable mode. The default
switchport mode for all Ethernet interfaces is dynamic auto.
Makes the interface actively attempt to convert the link to a trunk link. The interface
becomes a trunk interface if the neighboring interface is set to trunk, desirable, or auto
mode.
Puts the interface into permanent trunking mode and negotiates to convert the
neighboring link into a trunk link. The interface becomes a trunk interface even if the
neighboring interface is not a trunk interface.
Prevents the interface from generating DTP frames. You can use this command only when
the interface switchport mode is access or trunk. You must manually configure the
neighboring interface as a trunk interface to establish a trunk link.
Configures the interface as a tunnel (nontrunking) port to be connected in an asymmetric
link with an 802.1Q trunk port. 802.1Q tunneling is used to maintain customer VLAN
integrity across a service provider network. See
and Layer 2 Protocol Tunneling,"
lists the Ethernet trunk encapsulation types and keywords.
Function
Specifies ISL encapsulation on the trunk link.
Specifies 802.1Q encapsulation on the trunk link.
an ISL (preferred) or 802.1Q trunk, depending on the configuration and
capabilities of the neighboring interface. This is the default for the switch.
Sets the ethertype value for 802.1Q encapsulation. Used to select a nonstandard
(nondefault) 2-byte ethertype to identify 802.1Q tagged frames. The default
ethertype value is 0x8100.
This option is supported only on enhanced-services (ES) ports.
Chapter 13, "Configuring IEEE 802.1Q
for more information on tunnel ports.
Chapter 10
Configuring VLANs
78-15870-01
Advertisement
Table of Contents
Troubleshooting
