Monitoring And Maintaining Mpls And Eompls - Cisco Catalyst 3750 Software Configuration Manual
Metro switch
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Hardware installation manual (231 pages) ,
- Message manual (120 pages)
Table of Contents
Advertisement
Monitoring and Maintaining MPLS and EoMPLS
Switch(config)# interface gigabitethernet1/1/1
Switch(config-if)# service-policy output out-policy
Switch(config-if)# end
Monitoring and Maintaining MPLS and EoMPLS
To clear MPLS counters or display MPLS and EoMPLS information, use the privileged EXEC
commands in
Table 30-1 Commands for Displaying MPLS and EoMPLS Information
Command
clear mpls counters
show mpls forwarding-table
show mpls interfaces
show mpls ip binding
show mpls l2transport vc [detail] [summary]
show mpls l2transport vc [vc-id] [vc-id-min - vc-id-max] Display information about the specified VC or range of VCs.
show mpls label range
show mpls ldp bindings
show mpls ldp discovery
show mpls ldp neighbor
show mpls ldp parameters
show mpls prefix-map
show mpls ldp backoff
Catalyst 3750 Metro Switch Software Configuration Guide
30-22
Table
30-1.
Purpose
Clear MPLS forwarding counters.
Display the contents of the MPLS label forwarding information
base (LFIB).
Display information about interfaces that have been configured
for label switching.
Display specified information about label bindings learned by
LDP.
Display detailed or summary information about the EoMPLS
virtual connections that have been enabled to route Layer 2
packets on a provider-edge device.
The range is from 1 to 4294967295.
Display the range of local labels available for use on packet
interfaces.
Display the contents of the label information base (LIB).
Display the status of the LDP discovery process.
Display the status of LDP sessions.
Display current LDP parameters.
Show the prefix map used to assign a QoS map to network
prefixes that match a standard IP access list.
Display information about the configured session setup backoff
parameters and any potential LDP peers with which session
setup attempts are being throttled.
Chapter 30
Configuring MPLS and EoMPLS
78-15870-01
Advertisement
Table of Contents
Troubleshooting
