Configuring Storm Control - Cisco 3032 Software Configuration Manual

Hide thumbs Also See for 3032:

Table of Contents

Configuring Port-Based Traffic Control

This chapter describes how to configure the port-based traffic control features on the switch. Unless

otherwise noted, the term switch refers to a standalone switch and to a switch stack.

For complete syntax and usage information for the commands used in this chapter, see the command

reference for this release.

This chapter consists of these sections:

Configuring Storm Control

These sections contain this conceptual and configuration information:

Understanding Storm Control

Storm control prevents traffic on a LAN from being disrupted by a broadcast, multicast, or unicast storm

on one of the physical interfaces. A LAN storm occurs when packets flood the LAN, creating excessive

traffic and degrading network performance. Errors in the protocol-stack implementation, mistakes in

network configurations, or users issuing a denial-of-service attack can cause a storm.

Storm control (or traffic suppression) monitors packets passing from an interface to the switching bus

and determines if the packet is unicast, multicast, or broadcast. The switch counts the number of packets

of a specified type received within the 1-second time interval and compares the measurement with a

predefined suppression-level threshold.

Configuring Storm Control, page 26-1

Configuring Protected Ports, page 26-6

Configuring Port Blocking, page 26-7

Configuring Port Security, page 26-8

Displaying Port-Based Traffic Control Settings, page 26-19

Understanding Storm Control, page 26-1

Default Storm Control Configuration, page 26-3

Configuring Storm Control and Threshold Levels, page 26-3

Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide

C H A P T E R

Table of Contents